USED - ONLY 5 MONTHS

Capacity
to 12” wide material and 4’ to 16’ long (can have an option added to handle shorter and narrower material at increased throughput rate)

Suitable for a production of up to 50 boards, 4' to 16' long per minute.

Note – Machine can be modified to run shorter materials if desired

End-Matcher, 12 foot wide deck model DH-2S with “Soft-Touch” hold downs and even-ender belt:

Machine Description and Some Features:

• Traverse bar conveyor approximately 12 feet wide by 27 feet long
• The traverse bar conveyor is covered by a 0.375”thick layer of UHMW
• Powered by a 20 H.P. hydraulic drive with thermostatic fluid heater
• Adjustable feed speed up to 80 FPM
• 2 side-shift roller conveyors, 1 x 24” wide and 1 x 36" wide
• Solid traverse bars 15" center to center
• Traverse bars for 0.75" to 1.50” thick material
• Even-ender belt suitable for soft wood for boards up to 16 feet long
• Gravity exit system with pneumatic dampers,
• Two Ductile Iron Chains, one central roller chain
• Automatic chain lubrication system (oil mist)
• Machining centers equipped with saw guards and dust collection outlets
• Five - 5 H.P. spindle motors and two - 3 H.P. spindle motors (with dynamic braking feature) for machining

ADDITIONAL FEATURES INCLUDED:

• "Soft Touch” Hold Downs for end-matching top and bottom of softwood as well as hardwood boards,
• Jump Scoring Saw – tongue machining center: to prevent tear out on the top front corner on tongue side (powered by trim saw motor - applies to square top or micro-bevel)
• Jump Scoring Saw – groove machining center: to prevent tear out at the intersection of rear groove and end groove, powered by a 1 HP motor
• Complete Set of Tooling

Condition: Excellent Condition as it was only used for approx. 5 months prior to shut down

LISTING # : EM DOU DH-2S-C1-060110