Ideal for Dunnage, Kiln Sticks, etc. Cast iron base w/easily accessed Anchor Bolts Lift Up Sound Enclosure for quieter and safer rip saw operation Table and Guide are Hard Chromed Hydro-loc Outboard Bearing System for best gang sawing shaft support with grease gun Cardan Shaft Drive throughout All driven rolls – hence a very solid true drive 6 Driven Close Coupled Top feed rollers Top Rolls are Air Tensioned 4 Driven Bed rollers Variable Pressure Controls – on top feed rolls Motorized Lift to Top Rolls Saw spindle has motorized lift and lowering Belt Driven Saw Spindle Saw blades cut from below hence better Dust Removal and a heavier sturdier design Saws are pre-mounted on a slip on sleeve for quick change. Anti-Kickback Devices included Central Lube System Star-Delta Main Saw motor Starter – hence low amperage start Pneumatic infeed pressure rollers Spring loaded side pressure on infeed table   • Control Panel       • Pneumatic controls for feed roll pressure       • Outboard bearing door for spindle support       • Back view of enclosure       • Cardan drive feed system     SPECIFICATIONS:   • Maximum Thickness 5.1" (130mm)   Note - available to 5-1/8" max. thickness with factory order   • Maximum between Outside Saws 11.75" (300mm)   • Minimum length material 10" (250mm) - at slower sppeds  • Saws 10" min. to 14" max. Dia. x 70mm Bore (dbl key). 50mm dia. spindle with 70mm dbl keyed sleeve x 4,000 RPM   • Main Motor - std. 50 HP (max. 355mm (14" dia.) blades)  • Top Feed Rolls - Rise & Fall 1 HP   • Feed Motor 7.5 HP with VFD Infinitely Variable Speed Control Inverter   • Saw Sleeve 70mm dia. with 2 x 20mm keyways  • Vari-speed Feed 20 to 165 FPM (6 to 50 m/min.)  • Mag. Starter and Electrics to UL/CSA Standards • Dust Collection Outlets 4 x 6" dia. (2 top, 2 bottom)    OPTIONAL EQUIPMENT:   Infeed Side Pressure   60 HP Main Motor   75 HP Main Motor   Spare Sleeve